Parts » Handlebars » Other »

Zipp Vuka Alumina Extensions (22.2)

General

Features	Guidelines for cutting extensions: The extensions are marked on the underside in 1 cm increments with half centimeter increments shown with smaller lines. A minimum of 3 cm of extension must be inserted into the VukaBullet body to avoid damaging the extensions. This means that a minimum of six marks (three large and three small) must be inserted into the bar after the bars are cut to length. If more than 4 cm of extension need to be removed, we recommend removing in 2-3 cm increments to avoid overcutting of the extensions. The extension should be wrapped in masking tape at the point where it will be cut and cut with an aluminum-specific hacksaw blade. The masking tape will help ensure that the cut is clean and no jagged fibers lift off of the part. Warning: Do NOT cut anything from the front end of these extensions.
Recommended for	Triathlon, Time Trial

Features

Guidelines for cutting extensions:

The extensions are marked on the underside in 1 cm increments with half centimeter increments shown with smaller lines. A minimum of 3 cm of extension must be inserted into the VukaBullet body to avoid damaging the extensions. This means that a minimum of six marks (three large and three small) must be inserted into the bar after the bars are cut to length.
If more than 4 cm of extension need to be removed, we recommend removing in 2-3 cm increments to avoid overcutting of the extensions.
The extension should be wrapped in masking tape at the point where it will be cut and cut with an aluminum-specific hacksaw blade. The masking tape will help ensure that the cut is clean and no jagged fibers lift off of the part.

Warning: Do NOT cut anything from the front end of these extensions.

Recommended for

Triathlon, Time Trial